Product Category:Pneumatic lumbar massage Product Code:HS-SMP02 Nominal voltage(V):9V-13.50V Max current(A):<1A Rated power:8W Automatic switching time:10seconds Net weight/gross weight:0.50kg/1kg Carton size:360*300*60mm
Installation method
Step 1: lift the holster up.
Step 2: Insert the air bag part of the massage system from the back of the seat, the middle seam between the back and the cushion into the front.
Step 3: Tear off the double-sided adhesive on the back of the massage air bag, the bottom is flush with the bottom of the seat sponge, and the massage airbag is evenly pasted on the seat back sponge.
Step 4: When installing the airbag, pass the vent tube through the sponge, clamp it on the back, tighten it (so that the panel is flat against the back of the chair), and connect it to the air tube of the control box.
Step 5: Connect the electricity: Method one, take the electricity at the cigarette lighter, configure the cigarette lighter connector yourself; Method two, take the electricity from the original car circuit (the red wire is connected to the positive pole of the power supply, do not connect it reversely).
Step 6: Connect the power cord and the control box connector.
Step 7: Fix the switch on the plastic shell on the side of the seat, restore the holster, and gently tap to make the holster completely flat.
Step 8: Restore the seat, test it after connecting to the power supply, and the installation is complete.